Conserve & Seal™

Technical Information

Preparation:

Surfaces should be clean from dust, dirt, oils, grease, curing compounds, other coatings, e­fflorescence and laitance before applying PCA Conserve & Seal™.

Application:

1. Ensure the surface is clean and dry
2. Surface sealer and repellents must be removed prior to application.
3. Cover surfaces not intended to be treated.
4. Saturate an even first coat using a low-pressure sprayer, lambswool applicator, paint brush or dipping. It is recommended to use a pump sprayer on rough surfaces.
5. Allow sealer to penetrate the surface for 5 – 15minutes.
6. Typical treatments involve 2 – 3 cycles (6-9 separation application)
7. Please allow 20 – 60minute curing time between each cycle.
8. After final application, thoroughly wipe all excess sealer with clean and absorbent towels.
9. If a second treatment is required, allow 2 – 3 weeks curing time following the initial treatment.
10. It is important that no water comes into contact with newly treated surfaces for at least 2-3 days after application.
11. Clean tools used during application with methylated/ white spirits or solvents.

Coverage:

Application rate depends on the degree of the surface deterioration, temperature and method of application. Coverage ranges between 0.5 – 4 sqms per litre. USE AS IS, DO NOT DILUTE.

Maintenance:

For regular cleaning use PCA Stone Soap™. For heavy duty cleaning use PCA Stone Degreaser™.